Skip to main content

Full Wave Bridge Rectifier With Capacitor Filter

 Full Wave Bridge Rectifier With Capacitor Filter

The voltage obtained across the load resistor of the full-wave bridge rectifier described above has a large
amount of ripple. A capacitor filter may be added to smooth-en the ripple in the output, as shown below.
Figure 21: Full wave Bridge rectifier with capacitor filter
The rectifier circuits discussed above can be used to charge batteries and to convert AC voltages into constant

DC voltages. Full-wave and bridge rectifier are more commonly used than half-wave rectifier.

Comments

Post a Comment

Popular posts from this blog

BLDC Motor Driven Solar PV Array with Battery Fed Automatic Irrigation System Employing Zeta Converter

Objective The main objective behind this project is to design a simple, cost effective and efficient brushless DC (BLDC) motor drive for solar photovoltaic (SPV) array fed water pumping system. The project includes automatic changeover circuit to switch power source between solar panel and battery based on the presence and absence of light. The pump works on the signals received by the sensors used for automatic irrigation system. Abstract This project proposes a simple, cost effective and efficient brushless DC (BLDC) motor drive for solar photovoltaic (SPV) array fed water pumping system. A zeta converter is utilized in order to extract the maximum available power from the SPV array. The proposed control algorithm eliminates phase current sensors and adapts a fundamental frequency switching of the voltage source inverter (VSI), thus avoiding the power losses due to high frequency switching. No additional control or circuitry is used for speed control of the BLDC motor. The
Post a Comment
Read more

Nano Technology In Electronics

Post a Comment
Read more